Auto Spray Paint Booth

Auto Spray Paint Booth

Downdraft Car Spray Booth 6.9m Long Belt Drive Fan Diesel Burner Heating Features 1, Blet drive fan for intake and extraction. 2. All panels are tongue and groove interlock structure. 3, #304 stainless steel heat exchanger. 4, All LED lights, energy save and more illumination. 5, Color white,...

Product Details

Heating:

Diesel Burner Heating

Control Panel:

Schneider Components

Draft Type:

Pressurized Downdraft

Lighting:

LED Light, Access From Outside

Fan:

Belt Drive Type

Usage:

Car, Vehicle, SUV

Downdraft Car Spray Booth 6.9m Long Belt Drive Fan Diesel Burner Heating

Features

1, Blet drive fan for intake and extraction.

2. All panels are tongue and groove interlock structure.

3, #304 stainless steel heat exchanger.

4, All LED lights, energy save and more illumination.

5, Color white, blue, orange and red is optional.

6, OEM available.

Advantage:

In painting, outside fresh air comes into the heating generators through the pre-filter system, and enters into the plenum, then filtered by ceiling filter and into the both which brings clean, symmetrical and steady-going down airflow for spraying, After painting, inside the drying oven, hot air goes from heating generators to plenum, then enters room after filtered by ceiling filter, hot air circulation providing heat that is necessary for baking of cars surface. .

Spray booth specification:

Inside dimension

6900×3900×2650 mm(L×W×H)

Outside dimension

8450×4000×3400 mm(L×W×H)

Front door

Folding door, 3 folds, 3000×2600 mm(W×H), without frame, colour : blue.

Emergency door

1 unit, 650×1800mm (W×H), colour: blue, on the front door.

Basement

Galvanized steel assemble, 300mm high, quadrate steel support, full grilles made by flat bar and twisted steel, then galvanized. 2 ramps, external setting, 750×3000mm/pc.

Wall Board

Thickness:50mm, width:1150mm, tongue and groove structure, 0.376mm colour steel with 50mm thick polystyrene (EPS) insulation inside, colour: white.

Light

Ceiling Lights: 8Units×4Pcs=32Pcs×36W, with LED, lighting boxes open outside,.
  Side Lights: 8Units×4Pcs=32Pcs×36W, with LED, lighting boxes pen outside

Generator cabinet

Intake from rear upper direction, exhaust from rear upper direction, quadrates steel frame; white coated steel covered, filled with heat preservation material in the middle.

Intake and Exhaust system

2×3KW double-intake centrifugal fans for intake, motor outside, belt drive, model TAE-355, air capacity for each fan: 21000m3/h.

1×4KW double-intake centrifugal fan for exhaust, motor outside, belt drive, model TAE-400, air capacity: 12500m3/h.

Heating system

RIELLO G20 diesel burner, stainless steel heat exchanger, electric damper actuates from spraying to baking cycle. Max. heating productivity: 20000kcal/h. Max temperature: 80 degree

Purification system

Pre-filter, ceiling filter, fibreglass filter, activated carbon filter

Roof

Galvanized steel plates

Control system

Spraying, heat spraying, baking, time setting, lighting switch, failure indicator, thermostat, power supply switch, emergency stop, hour meter. Temperature limit controller, all motors are normal start.

Total Power

12.5KW


image001.jpg

Inquiry